Reported risk: The ball head connecting the brake pedal and the master brake cylinder the ball head might not be locked properly into the ball cage. If the driver accidentally pulls up the brake pedal the brake switch would be activated permanently. This will cause: The brake lamps to be illuminated even while driving A Check Control Message would not alert the driver. An engine start or gear selection would be possible without brake actuation. If the driver's door were opened after switching off the engine the gear would not switch automatically to P as designed. Remedy: Recall the vehicles that are likely to be affected and check the locking of the ball head on the brake pedal. If necessary the pedal mechanism will be replaced.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.