Reported risk: On certain vehicles, moisture could enter the rear wiring harness through a connection located underneath a drain hole in the truck bed and cause corrosion to form in some connection terminals. If corrosion of the rear wheel speed sensor terminals occurs, it could increase the electrical resistance and may be interpreted by the vehicle stability assist (VSA) as wheel slippage, resulting in a decrease of engine torque or brake application to the rear wheel(s). The unexpected and unnecessary application of brake assist while driving may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the rear wiring harness and corresponding rear drivetrain components for moisture and/or corrosion. If present, the dealer will replace the rear wiring harness and corresponding components as necessary. If there is no moisture or corrosion, the dealer will repair the rear wiring harness to eliminate the potential for moisture intrusion.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.