Reported risk: On certain motorcycles, engine vibration may cause the bank angle sensor’s wiring to rub on the wiring harness joint connector. Continuous vibration between the bank angle sensor wiring and the wire harness joint connector could cause an open circuit, which could result in an engine stall while riding. An engine stall could lead to a loss of stability of the motorcycle, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will relocate the joint connector and replace the bank angle sensor.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.