Reported risk: On certain vehicles equipped with Workhorse Custom Chassis, an incorrect steering intermediate shaft may have been installed. The incorrect part has a finer pitch spline. Use of the incorrect part may cause the spline not to match correctly with the steering gear input shaft. This could cause the spline to strip if the steering wheel is turned with a significant amount of force. This failure is likely only to occur when the vehicle is stopped or during tight turning manoeuvres at very low speeds. This condition may result in a loss of steering control. Correction: Dealers will replace the shaft.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.