Reported risk: On certain ATV's, the protective boots covering the steering system's tie-rod ends could be pinched during installation or operation, cutting a hole in the rubber. If this occurs, grease could escape from and contaminants such as sand or mud could get into the assembly through the hole, causing accelerated wear. If the ATV continues to be operated without repair, there is the potential that the ball and socket could wear to the point that they separate, resulting in loss of steering control. Correction: Dealers will install updated tie rods.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.