Reported risk: On certain motorcycles, the distributor connector cap of the main wire harness was improperly wired, causing one ground circuit to be apportioned an excessive load. If the connector overheats, the power to various circuits could be lost. As a result, a loss of critical lighting or engine power could occur without warning, which could cause a crash. Correction: Dealers will inspect the ground distribution connector and check for damage. If any damage is found, the dealer will install an improved main harness. If no damage is found, the dealer will install a reconfigured connector cap that will apportion the ground load correctly.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.