Reported risk: On certain motorcycles, the hex nut that secures the front drive belt wheel to the gearbox output shaft was torqued to a value less than specification during the vehicle assembly process. As a consequence, the nut could loosen during vehicle operation. If this happens, the belt wheel would itself loosen on the output shaft, resulting in damage to the internal splines of the wheel and to the external splines of the output shafts as the vehicle is operated. Over time, the splines could be damaged to the extent that the output shaft would no longer operate the drive belt, resulting in a loss of drive capability at the rear wheel. Correction: Dealers will check the torque of the hex nut and adjust is necessary. Note: This recall is superseded by recall 2003146.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.