Reported risk: Certain vehicles do not comply with CMVSS 1103 - Exhaust Emissions. Vehicles may been built with the ignition coil wire too close to metal brackets or the transmission fluid fill tube (M/L van only). If the coil wire is too close to these metal objects, arcing may occur and cause failure of the wires which can in turn lead to a stalling/no start condition and/or catalytic converter failures. Correction: coil wire will be repositioned to assure adequate clearance from metal brackets and/or transmission fluid fill tubes.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.