Reported risk: On certain B600, B700, F600, F700, F800, FT900, LA9000, LL9000, LTA9000 and LTL9000 vehicles, a connector where the wiring for lamps mounted on the tilt hood attaches to the vehicle wire harness was built without sealing plugs in the unused cavities of the connector. Road salt, moisture or other contaminants may enter the connector, which could result in crossed circuits, shorts or corrosion of the wiring in the connector and a malfunction of the headlamps or other front-end lighting systems. Correction: Sealing plugs will be installed in the unused connector cavities. If corroded, a new connector will be installed.
Verify each fact at the issuing agency before acting. Recall scope, affected lots, and remediation instructions may be updated by the agency after our last sync.
ProductGuru indexes recall and safety-alert records from ~30 public agency registries. We are not lawyers, regulators or product-safety consultants. This page restates what the named agency published; consult the primary source above (or qualified counsel in your jurisdiction) before any commercial, medical or safety decision.